Pvc tee piston valve

[turner]

Can anyone help me choose the fittings or a PVC tee piston for a 3/4 or barrel? I was thinking many a 1 inch tee and a reducing bushing for the barrel side but the pilot side is hat I can't figure out

[jrrdw]

Search in the Wiki and go to your supplier and physically match the parts up, it's one of the best ways to figure it out, hands on! Also, the how-to section here has great information about building piston valves in tee's.

[turner]

I've tried going to the store but they don't really like you back there much cause people steal like $300 a month in copper. Thanks for the advice though

[turner]

Does this sound right so far? 3/4 cpvc barrel, bushing to 1.25" tee small length of 1.25" pipe, cleanout, then cleanout cap with holes for fill/ pilot?I would like to you a 3/4 endcap for a piston

[inonickname]

Cleanout caps in general are unrated. Ensure all of your parts are pressure rated.

[cannon monkey]

lets see if i can help you


3/4 barrel -- 3/4 to 1.25 bushing -- 1.25 tee-- to 1.25 pipe ( short for piston to travle in ) --- 1.25 to 1/4 inch bushing-- 1/4 tee with fill valve of some kind and a ball valve


no clue if that makes any sence

[turner]

That makes sense but then you couldn't service the piston. Is it even posible with PVC?

[cannon monkey]

umm yes
what ur e mail address i got prints i can send u of a serviceble piston

[turner]

Turnerfromdh@gmail thanks