Types of epoxy?
-
Stolly32123
- Private 3
- Posts: 50
- Joined: Sun Jul 04, 2010 7:50 am
- Location: Australia
I am planning on making a cannon this weekend but im not sure what epoxy i should use. Could someone tell me the different types of epoxy and/or things i could use instead. Thanks!
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
If you want good advice, you'll need to be a bit more specific as to exactly what type of cannon of what size operating in what conditions.
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
Stolly32123
- Private 3
- Posts: 50
- Joined: Sun Jul 04, 2010 7:50 am
- Location: Australia
Ok. Im making a 6mm piston valve single shot rifle. I will be using a shock pump to pressureise it so it would be around 200 -250 psi.
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
As above, you can buy JB Weld/Araldite or similar at almost any hardware store. I made this 5.5mm piston valve launcher using basically brass tubes, araldite and masking tape 
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
SpudBlaster15
- First Sergeant 3
- Posts: 2400
- Joined: Wed Oct 18, 2006 11:12 pm
- Has thanked: 2 times
- Been thanked: 10 times
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.