Placing of a schrader valve

[jsefcik]

I just got a barrel sealing piston valve,
Im just stuck on where to put the scharder valve,

Two questions? can i put it in the bottom of my blow gun?

And if not where on my sprinkler valve can i put it?
I dont wanna use brass tees i think it looks crappy

please help!!!!!!!i want to build this beast!!!!

[wyz2285]

NOT in the bottom of your blowgun
you are using a sprinkler valve to pilot it? if so you can put it on the valve in the same place as the blowgun I think, search a little for examples

[mattyzip77]

Why not?? As long as he depresses the blowgun while filling, it should work???

[streetfire]

but if the blowgun pilots the sprinkler an schrader will not work properly because of the flow through the schrader. just drill a hole tap it and place it with epoxy works great

[mattyzip77]

actually, you just take the core out of the schrader valve!!

[streetfire]

that will work but if he is pumping wont it be hard too keep pressing the blowgun?

[mattyzip77]

He has a compressor, no pumping needed, but that was a good point!!

[jsefcik]

Im talking to gun freak on how to put it into the side of the sprinkler valve

[mattyzip77]

Im talking to gun freak on how to put it into the side of the sprinkler valve

Drill a hole, tap the hole, insert schrader valve, done!!

[jsefcik]

Im talking to gun freak on how to put it into the side of the sprinkler valve

Drill a hole, tap the hole, insert schrader valve, done!!

im just talked to him, im going to do it in a bit