Short question topic

[jackssmirkingrevenge]

Jack does your full auto reaches a 600 rpm? Because in the fastest ROF I can choose from the chip is 10 Hz(10 Rps).

I'm sure it does, you could check the video with audacity.

[POLAND_SPUD]

Jack does your full auto reaches a 600 rpm? Because in the fastest ROF I can choose from the chip is 10 Hz(10 Rps).

10 RPS is rather optimistic...
if you want to have 10 RPS whatever you're using as your air source has to be able to deliver 10 times the chamber volume in 1 second

though if you plan to use bbs that shouldn't be a problem


Ohhh and let me expand on my previous post... if you have a 5 way valve you could theoretically have two guns in one
if all you need is a nice little plinker for airsoft you could use the DCV itself as the main valve

and voila you've got two guns in one and effectivelly you doubled the ROF

since valves can be stacked toghter...
...as seen here

.... you could theoretically stack two valves to get 4 times the ROF... 3 to get 6 times the ROF of one gun... and so on

[wyz2285]

You blew my mind Poland! Hell yeah why not making a double barrel bbmg it would be spectacular

[Goats spudz]

will this Coupling hold 1000psi without leaking http://www.ebay.co.uk/itm/PRESSURE-WASH ... _678wt_952

[ramses]

Probably, assuming it has a rubber gasket. It was designed for water, so there might be slight leakage.

You still shouldn't try to disconnect it under pressure, though.

[jackssmirkingrevenge]

Only if used with a carbon fibre chamber

[Goats spudz]

Only if used with a carbon fibre chamber

Shhh. dont want to attract any trolls

and would a normal QC with a check valve behind it be better for releasing under pressure?

[ramses]

The issue is that the mechanism binds under pressure. The ball bearings lock against the sleeve and the other part. If you manage to move them (think hammer), you will significantly wear the quick connect.

[wyz2285]

Hi I´m making a new pcp rifle, and I´m planing using a stainless steel tube as chamber, 0.75mm wall. Is it safe to use 1000 psi with it?

[jackssmirkingrevenge]

What diameter is the tube? CO₂ cylinders have a similar wall thickness and are definitely safe at that pressure.

[wyz2285]

2.2cm id i think
(my first post through ipad )

[jackssmirkingrevenge]

2.2cm id i think

Sounds about right.

(my first post through ipad )

Booooooooooooooooooooooooo!!!!!!!!!!!!

[wyz2285]

Thanks, good to hear that, it looks kind thin so I was worried about the safety

[subterranean]

Where can i get some tubing with an Inner dia. of 4.5mm (.177 pellet) ?

[mark.f]

Go to an automotive store and buy some 1/4" steel brake line.