new project and need advice on power

[mattyzip77]

you can get a better one fron mcmaster for the same price, and you will get it faster because the other one you posted is in hong kong!!! Check out link below!!



http://www.mcmaster.com/#exhaust-control-valves/=hfl66l

[beastmode986]

oh ok then i thought they were plastic. where is the qev at mcmaster i dont see it

[beastmode986]

jsr i once again require assistance lol


ok so im not going to buy a qev because i did research and basically a brad nailer is a piston valve and i have a nailer that i am not using. its just like this but gray and made by true power(got it for 10$ new) http://menards.com/main/tools-hardware/ ... c-9076.htm

anyways im having a problem i tried doing a few test shots and not all of the air gets released at once how do i fix this? i saw an old thread and jsr posted an animation. From what i could tell i just remove the "striker thing" i already removed the pointed peice on it but i left the thing it was attached to inside. so i assume i should remove that,fit my barrel and epoxy it in place correct? also do you think tis can handle 400 psi? or will it blow up in my hand?

[jackssmirkingrevenge]

http://www.spudfiles.com/forums/semi-au ... 15892.html

http://www.spudfiles.com/forums/coin-la ... 10845.html

http://www.spudfiles.com/forums/nailgun ... 10955.html

[Crna Legija]

I had the same nailer crack at 250psi where the screws are at the back.

[beastmode986]

ahh my stupidity got the best of me i should have searched better.
anyway.... so i assume its safe to use at 200 psi max? assuming it cracks at 250psi? so now that i kno that id rather get the qev ill buy one right now but if i do so that leaves me enough for a 300 psi shock pump instead of a 400psi pump..... thanks alot for the help!

[mattyzip77]

Its under right angle valves in the link in my previous post.

[beastmode986]

im just ordering one in the us from ebay i just ordered a shock pump and ammo and am buying the qev later today.