My COmbustion CAnnon

Boom! The classic potato gun harnesses the combustion of flammable vapor.
Post Reply
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

hey Guys

well its been a little while since ive been building. Took a bit of a break sold all my cannons too friends. money was very tight. But im building another combustion. Its like a modded version of pete zaria's basic reliable cannon with the propane meter and stuff. Anyways what type of bit should i use to Pilot a hole to hand screw 3/4'' brass nipple to.



THanks
Haylo_stealer
Last edited by HAYLO_Stealer on Mon Nov 06, 2006 9:19 pm, edited 1 time in total.
Top
User avatar
SpudStuff
Sergeant 5
Sergeant 5
Posts: 1410
Joined: Sat Dec 10, 2005 3:55 pm
Location: Cupertino, California
Contact:
Contact SpudStuff

1" Should do the trick if you drill it perfectly streight.
Top
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

I should be able too so 1'' bit should to it
Top
User avatar
SpudStuff
Sergeant 5
Sergeant 5
Posts: 1410
Joined: Sat Dec 10, 2005 3:55 pm
Location: Cupertino, California
Contact:
Contact SpudStuff

Yes, the pipe is 1.050" OD.
Top
User avatar
HAYLO_Stealer
Private 4
Private 4
Posts: 87
Joined: Thu Feb 23, 2006 2:02 am
Location: USA, TAMPA, FLORIDA

where can i get a 1" bit and about how much do you think it would put me out.
though im going to rip of lowes anyways. Ill buy it use it refund it.
Top
Post Reply

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post

Return to “Combustion Cannons”