Mini Pill Bottle

[spudshot]

OH ok, well there should be a piece of metal at the bottom of the peizo which you tape/solder wire too, and there should also be either a wire, or a metal tab on the side somewhere you tape/solder another wire to

[saladtossser]

there are two types, a bad one is black and has a big metal cylinder on the bottom that solder doesnt stick to, a white one will have 2 small electrobs that are easily solderable(is that a word?). use the white one.

[saladtossser]

thats 3 posts of the exact same thing
a big one wouldnt hurt, a small on wouldnt hurt too, just dont choke the flow and keep a good c:b ratio. i think the only advantage of a big chamber is that u can fit a fan in it, but a 2" chamber ignites just fine without one.

[crod]

so wait...all u have 2 do is spry the fuel down the barrel put the Q tip in and press the igniter button?

[spudshot]

you put the q tip in first to stop the fuel (you spray in from the bottle cap) from escaping out the barrel, the ignitor is wired to 2 screws on the gun so the electricity will make a spark

[Bedo]

hey i was just wonderin how big yur pill bottle is?

[Hal0 x]

That s pretty cool..wish i was good enuogh to make somthin like that...alas im a a noob at this.

[goatwrangler500]

haha thats allot of fun i used spray paint for it but i usuly have to air it out a bit before it will shoot y is that

[spudshot]

because there is too much fuel in it, i wouldnt use spray paint, it'll leave a residue, and if its an oil based paint it might just burn. try using a spritzer bottle of cologne, a small spritz is the perfect amount

[goatwrangler500]

iv been shooting spit wads through it

[deathtodeer666]

hey be careful when you solder a piezo igniter because they melt real easy

[saladtossser]

i did it once, no problem, just be quick.

[Bedo]

i used epoxy to glue the pen tube to the pill bottle but the epoxy just flaked off so i took in apart

would hot glue work fine?

[saladtossser]

not fine, it will work a few times, and get weakened

[Bedo]

hm....then what else could u use besides taping it down?

i was also thinkin of gorilla glue or anyother type of super glue?