pipe sleeving

[Killjoy]

yeah but doing that could result in some dripping into the valve, and usually thats a bad thing.

[paaiyan]

Not if you do it right. Take a thin roll of paper and stuff down into the crack a bit and it'll keep it from dripping down. Or you could just use 5-minute epoxy, set the gun on it's side so it can't drip down and rotate it every half minute so it doesn't all slither to one side.

[imforcedtodothis]

i could just mix the epoxy normally then thickly coat the outside of the pipe and inside of the valve tube. i could just hold the vale so the epoxy would drip towards the end.... would this work?

[paaiyan]

umm... Probably. It just wouldn't look as clean.

[sjog]

It's a barbed fitting why are you going in side?
Pressure hose-- rubber --then the rigid barrel

[imforcedtodothis]

i'd rather not have a hanging barrel...