Help with muzzle brake

[Mr.Russ]

hey im tryin to put the holes in it, and i dont understand how im gonna spread em out.

it is 9cm perimeter, and 4cm long. i would ideally like the holes to be 1cm diameter.

If you could just explain how i would do it that would be great. thanks in advance

[TwitchTheAussie]

Get a hand drill or other drill if you have one handy, select the trusty 10ml drill bit, place where you'd like your holes to be with a texter then drill away. Take it slow and dont put too much pressure on it or it will break.

[Mr.Russ]

i know how to drill, im trying to work out where to place the holes... like so there even.

[rna_duelers]

Why not try a linear muzzle break?The linear compensator re-directs the gas flow to change the direction of the force more efficiently then just holes,if built properly.Wether or not the muzzle break is going to perform its purpose in the real world is debatable though.

Also they are meant to increase accuracy with long projectile(Not Round).Don't hold that fact to me though.

[Mr.Russ]

its kind of just for looks (lol)

i figured it out. no need to worry

Close thread if needed

[boilingleadbath]

There was this one guy who wrapped graph paper around his tubes to aid in hole alignment... I'd assume he transfered the co-ords onto the pipe with a center punch or similar.

...and please - don't just tell us that you figured it out.
Contrary to popular belief, you are <b>not</b> the only person in the universe who wants to know this - give back to the forum by telling us how you did it.

[Mr.Russ]

i just decided on using .5mm holes. space the holes centre 1cm apart therefor leaveing .5 of a cm in between each hole.