air hose ristriction?

[experament-u2]

would this work with the air hose or would it restrict flow to much



the chamber is 25mm pvc to a 25mm pvc T

plz can someone help me

[sgort87]

As long as your hose ID is not smaller than your barrel ID, you are fine.

Your valve looks way bigger than you need.

[frankrede]

Why not use some black iron or brass fittings?
And you will have a lot of constriction with your current setup/

[experament-u2]

the funny thing is the barrel will be 6mm and that picture was just to see if it would work to use air hose instead of a T

i using a 25mm t because iv alredy attempted in a 20mm t and it hasn't turned out very well due to the wrong fitting being available so im moving it up to a 25 were i know i can get wat i need and hopefully be able to get it working

[sgort87]

It's going to open too slowly to get a good effect. Use a small QEV.

[experament-u2]

were can i get one of them other than mcmaster i live in australia and haven't being able to find any

[MrCrowley]

I know where you can get 1/4" 3/8" 1/2" and 3/4" QEVs in Aussie....

starting at $35AU for a 1/4"

http://www.rsaustralia.com/cgi-bin/bv/r ... ningUser=N

search for 'quick exhaust' then scroll down till you find several familiar looking 90* QEVs