50mm/2" sprinkler venting.

[rna_duelers]

Now I have an order for a gun with a golfball barrel.A 150cm 50mm barrel 40mm barrel in an over under configuration.

Now thats out of the way.The valve is a 50mm/2" sprinkler valve which the person ordering wants to be launched with a simple squeeze of a trigger like a blow gun,but I was wondering if a modded blowgun would work very well,well actually I know there is much better ways of exhausting but I do not want to add a 25mm or 20mm sprinkler valve on top of the 50mm valve which doesn't look very good which is important with orders like this.

Just wondering what performance I would get out of this valve.Anyone that has modded one of these valves can provide some information it would be great.

Thanks for your time.

[schmanman]

it wont be as good as It could be, but how would the customer know?

it should provide decent preformance, but certainly nothing to brag about.

[super spuder]

do you own a business selling spud guns, anyways, a blow gun will work, but a ball valve would be better, but the customer gets what the customer wants

[rna_duelers]

Well I do a little here and there,its mainly from word getting around.I get calls from people friends asking could I get a golball gun made or can you moddify me a Sprinkler valve etc.I didn't even plan to get into buisness but it happend.


I am going to have a 1/4 ball valve then the blow gun attached to it,so if more performance then remove the blowgun and use the ballvalve.