Is this fitting pressure rated?

[Yonderknight]

Hi

I just bought some new parts to upgrade my spud gun recently, but I'm not so sure whether this 3" endcap is safe or not. I thought it looked a little different from the other end-caps I had, but wasn't sure whether it was like that because it was bigger.

On the edge it says SCH40 PVC-1 IPS [NSF-PW] 3 DURA USA
but I don't see any pressure ratings.

I've also took a picture, sorry about the crap quality (cell phone pic). Anything look obviously wrong?

Thanks in advance!

[Insomniac]

Well it says nsf-pw so I think its pressure rated, but I don't know what pressure its rated to.

[Yonderknight]

Hrm okay, as long as it's not the "other kind' of pipe that isn't rated. I'm not going to be pushing the pressure too high.

Thanks =).

[Specialist]

i think i have an end cap similiar to it and i think its only rated to 23 psi or somewhere around there. i could be wrong though.

[noname]

NSF-PW fittings are exactly what everyone else uses too, you're fine.

[Specialist]

oh sorry then. i have an end cap that i use for combustions thats only rated to like 30 or something. sorry again.