Duct tape valve

[hi]

Today was one of those days at school when you are really bored. i was looking in my desk and i noticed i had a disposible dixie cup and a roll of duct tape.

i want to make a low pressure valve that will release air when it is blown up. i want to be able to blow up the "tank" with lung pressure, about 3-4 psi.

The materials i have avalible are a plastic disposible cup, duct tape, elmer's glue, and a roll of duct tape + what ever else is in a common school desk.

what i will do with the thing is unknown, i just want to see if i can make one. any ideas?

[keep_it_real]

You're basically trying to make a burst disk right? I think it would be hard to find something that makes a seal but breaks at 3-4 psi.

[hi]

no, not a burst disk, my lungs can't produce that kind off pressure. i have no idea what kind of valve, just one that hold and release air.

[mopherman]

tissuse paper covererd with a thin layor of glue and left out to dry should bust at realativly low pressure. good luch at a union made out of duct tape

[paaiyan]

Wait wait wait, you have dixie cups and a roll of duct tape in your desk at school? There's gotta be some story there.

[mopherman]

i wish i had duct tape at school. lol

[Velocity]

I have considered building a duct tape pneumatic before as well

[Fnord]

empty the glue bottle and make it into a pump. you can probably make a check valve with a marble or an eraser+spring from a pen.

If you can actually generate 4 psi by blowing, (insert joke here).

[super spuder]

um. Is there plastic wrap in the desk? That would burst at lung presure.

[hi]

the dixie cups are from a bake sale and I found the duct tape, that satify you?

i like the TP idea, but i still want and actual valve, not a burst disk. i have thought for hours and couldnt think of anything.

[super spuder]

you could do what i thought of doing. go into the music room and hack apart a trumpet to get the valve

[mopherman]

make a swing check valve out of the cups and a duct tape disk. then tye a string on the swing part so you can pull the swing back.

[hi]

make a swing check valve out of the cups and a duct tape disk. then tye a string on the swing part so you can pull the swing back.

i like that idea...

fnord- even better idea, hey ill do both!

super spudder- i didnt know they had valves, but good idea.

[hi]

ohh, i got one...

ill make a check valve out of a pen body and use a airsoft bb as the piston and the spring from the pen to seal it and an eracer as the seal face. i could pull it open with a string.

this would be 100% absolutly useless/pointless, but would be fun to show my teacher.

[super spuder]

haha. i just made a tennis ball cannon to show my tennis teacher after school