blow guns

[super spuder]

I was just wondering if there is anyway to mod a blow gun to make it flow more air? I did a search but all i could find was moded sprinkler valves. Any help would be appreciated

[ArticWolf]

I would think that you can drill the hole inside a little bigger providing you don't go bigger than the trigger system inside, and that you don't drill into the trigger system. That would be a bad thing LOL just make sure that you clean out all shavings from dilling so it dont mess up the rubber seal inside hope that helped a little. I haven't done the Pnuematic thing yet but will do after the contest. All I know about blow guns is by what I read. I like copper it is shinny LOL that's what I'm using next, just got to practice soldering copper.

[chaos]

yes there most certainly is to answer you question,

http://www.spudfiles.com/spud_wiki/inde ... dification

[super spuder]

thanks chaos, and arctic wolf

[chaos]

anytime mate.

just be sure to search as much as ya can (not being mean btw)

[ArticWolf]

No problem. Thats what were here for to help one another. LOL

[chaos]

Oh yer i forgot to say, now that we helped you you have to vote #1 s400 in the contest. sorry i should put a disclaimer on my posts lol




jokes, but still...S400~ by Chaos #1

[super spuder]

yea, i will think about voting for the s400.