My newest Pneumatic

[SpoonZ]

Well, this will be my second pneumatic to date.

Its all PN12 piping and PN18 Fittings.
Sprinkler valve with Blowgun modification and a modification of my own to improve flow through the valve which works amazingly.

50MM chamber and 32MM barrel. The cannon sits around 1.5mtrs high.
Not sure about FPS atm but damage is pretty nice. Should be making a piston valve on the weekend, I will post some better damage pics after that.

The whole cannon






Wax slug at 100PSI







And finally a video of wax slug at 100psi. It doesnt show that much. It was windy as hell and no one to hold the camera.



And yes. The solenoid is still on there . Until I get marine epoxy anyhow.

[jackssmirkingrevenge]

nicely done, you need something a bit more belligerent than a poncy wax slug though

[SpoonZ]

Yeah. hah. I couldn't find anything to fit in the barrel perfectly. D size batteries do but I have none :S.

[rna_duelers]

Good to see more Aussie guns on here!Nice to see you used PN12.Don't use below PN12 in Pneumatics .Oh and any old epoxy will work doesn't have to be marine.

[jackssmirkingrevenge]

Yeah. hah. I couldn't find anything to fit in the barrel perfectly. D size batteries do but I have none :S.

grab a C or AA size barrey and wrap the tail end in wide masking tape until you get the barrel diameter, you get added stability to boot