Coaxial Piston Question
Most nylon should be durable enough for a piston... You need to be more careful when turning in a lathe than with derlin, however, as you will need to make lighter cuts at slower speeds to avoid melting... I doubt that you will end up with a piston that is too light...
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 7 Replies
- 2328 Views
-
Last post by inonickname
-
- 16 Replies
- 6508 Views
-
Last post by noname
-
- 2 Replies
- 1310 Views
-
Last post by MrCrowley
-
- 3 Replies
- 10505 Views
-
Last post by jackssmirkingrevenge
-
- 0 Replies
- 5779 Views
-
Last post by wereboar
