Idea for semi-auto layout

[clemsonguy1125]

It could be used with a few mods to you design look at c11mans semi, that seems like a simpler semi, plus it had more power than most semis, then again I havent made a semi like yours or c11man so Im not gonna give any more suggestion till I actually build on. Do you want multiple shots from the tank or are you staying hooked up to a compressor, my suggestion would indead be pointless if its meant to be portable

[Gun Freak]

It could be used with a few mods to you design look at c11mans semi, that seems like a simpler semi, plus it had more power than most semis, then again I havent made a semi like yours or c11man so Im not gonna give any more suggestion till I actually build on.

c11man's is more powerful cause it shot GOLF BALLS! keep giving suggestions though

[clemsonguy1125]

Yes but compared too other semis if scaled up it would have more power to because it dumps the whole tank

[Gun Freak]

And my design doesn't dump the whole tank?

[clemsonguy1125]

Well then is it semi cause you have to refill the tank, or is it hooked up to a fridgy or compressor

[Gun Freak]

It has an onboard airtank, remember I told you it would use a FE.

[clemsonguy1125]

Yeah but you just said it dumps the whole tank

[Gun Freak]

It dumps the whole chamber, then the tank refills it through the 3way.

[Gaderelguitarist]

I'm not exactly sure what you mean in that first paragraph. If the cylinder were to be commercially bought, then it would be rather long and could act as a foregrip. This design was to be put to a semi airsoft sniper in which case the cylinder would be homemade, like I mentioned earlier and would only be a few inches long, with the rest of the air chamber extending under and parallel to the barrel so it would be more sniper-like.

Sorry for the late reply

Essentially, I was saying that the force of the cylinder rod may damage the seat against which the ammo lies before firing. When the rod pushes a round up, that impact may adversely affect the piece used to connect everything together. I of course assumed it would be fashioned from either aluminum or epoxy because those seem to be the most common custom fitting materials.

As for my fore-grip comment:
You could easily fit a grip of some sort over the cylinder body. Think along the lines of a bike handle grip. While the length of the cylinder would not ultimately determine the length of the grip, it would indefinitely be a good way to add a bit of pizazz.

[c11man]

It could be used with a few mods to you design look at c11mans semi, that seems like a simpler semi, plus it had more power than most semis, then again I havent made a semi like yours or c11man so Im not gonna give any more suggestion till I actually build on.

c11man's is more powerful cause it shot GOLF BALLS! keep giving suggestions though

and its more powerful because i used a piston valve instead of Clides less powerfull valve, of cousrse mine used a ton more air....

and i just finished up anouther semi/full auto today, this one shoots 1inch solid plastic balls and is more efficent, it is very similar to the golfball one expect smaller of course

[Gun Freak]

Ok I understand now but that would be an easy thing to avoud since I am making my cylinder.