Electrically Triggered Pneumatic Cannon (Updated)

[walapu]

I am new here and I would like to show my first cannon. The barrel is 2" and a unmodded sprinkler valve with a safety. I normally launch it at 170psi. Most common ammo that I use for it is potatoes and pvc pipe with rubber heads. I have cleared my entire block but got yelled at by my neighbor. Now no more launching down my street










Ammo

[Crna Legija]

nice but you should really try get a sprinkler valve and mod it its not hard



that should help if you dont no about it and if you live in aus at bunnings u get them for like 25 bucks

[inonickname]

Ball valves aren't used on high powered/high end cannons. While they have excellent flow (basically 100% of the thread size), are easily obtainable, are simple to incorporate into a cannon and are cheap they have poor opening times.

You will notice improved performance by:

a) using a valve that doesn't constrict the flow
b) using a faster valve (sprinkler valve/diaphragm valve, QEV/piston valve, burst disk et cetera)

Though pretty nice! It doesn't look like you have unrated fittings on there and it's all done very cleanly! I'm sure it's just fine to plink with.

Perhaps a shoulder strap could be helpful?