home made hammer type valve

[Moggle NZ]

made in about 5 mins very simple made from bits i found in my sheed

this is not the 1 i will use a on a gun im makeing i just made it to see
i would preffer to make a good 1 out of a soilid bloc of alum



the qev



explaind a bit

[evanmcorleytv]

Looks good!! I'd like to see a launcher accompany it!!

[quark1980]

agreed

did you have one in mind?

[Zeus]

If you put a female tee on the outlet of the valve, then put the barrel all the way through and seal it with epoxy, drill a hole for the air inlet and make a bolt, you'd have a very nice launcher.

[Gun Freak]

That tee looks like compression... If I could find male tees I would have probably made my valve. Looks good...

[quark1980]

If you put a female tee on the outlet of the valve, then put the barrel all the way through and seal it with epoxy, drill a hole for the air inlet and make a bolt, you'd have a very nice launcher.

yup thats basicly what i did, except i used aluminium and steel

you still would need a hammer mechanism... any toughts on that?

[jakethebeast]

in-line hammer would be quite simple to make