spudgun tank

[mr.potatohead]

would it be safe to use a tank from a mapp gass torch but the same tank that i would refill with air

[jsefcik]

so your just asking, can i use an empty mapp gas tank as an air tank?

[mattyzip77]

would it be safe to use a tank from a mapp gass torch but the same tank that i would refill with air

Sure, why not!!! You would just have to remove the insert I believe!!

[jsefcik]

would it be safe to use a tank from a mapp gass torch but the same tank that i would refill with air

Sure, why not!!! You would just have to remove the insert I believe!!

id put a scrader valve into it to make it easier to fill

[mr.potatohead]

wait so how do i remove the insert a dril???

[jsefcik]

wait so how do i remove the insert a dril???

i would drill it all the way out and tap threads in for a schrader valve

[mr.potatohead]

k but i must make shure its empty before i ndrill the hole cause it can explode right

[mattyzip77]

ummmmmmmmm, yes. You should have been a rocket scientist!! :toothy10: @ jsefcik, how can you tell the kid to drill and tap a schrader valve if you do not even know what kind of cannon he is building??? :sign6: :sign6:

[Cosmic Muffin]

You'll want to drain it completely before putting any sort of drill bit/ cutting edge to it, thats what id do anyway, i need my hands and face.

[MrCrowley]

I think people find a way to fill them with water before drilling in to them, perhaps you can depress the valve and submerge it in a bath. I'd try that before ever drilling in to it.

[Technician1002]

Use a schrader wrench and remove the cores of both the over pressure valve and main valve. Use an air compressor to purge the tank with air, With the gas blown out, it may be drilled larger.

I did this on a cannon using a propane tank.
Even was safe to weld with an air supply to blow out fumes and prevent a dangerous build up due to heating.

[jsefcik]

ummmmmmmmm, yes. You should have been a rocket scientist!! :toothy10: @ jsefcik, how can you tell the kid to drill and tap a schrader valve if you do not even know what kind of cannon he is building??? :sign6: :sign6:

he said hes using it as an air tank duh lol

[Gippeto]

Do as Tech suggests.

Have drilled one out to 7/16" and tapped it for 1/4" npt...works well enough.

[mr.potatohead]

Use a schrader wrench and remove the cores of both the over pressure valve and main valve. Use an air compressor to purge the tank with air, With the gas blown out, it may be drilled larger.

I did this on a cannon using a propane tank.
Even was safe to weld with an air supply to blow out fumes and prevent a dangerous build up due to heating.

so wait i shoud empty the mapp gass then i should fill it with ai then empty it then remove the mail valve

[POLAND_SPUD]

lol I see you have problems with reading comprehension

release all the gas left
remove cores from both the over pressure valve and main valve...
once that's done whatever you blow into the tank through one of them goes out through the other one