CNC bbmg

[Karmatheninja]

Hello guys. I was in the process of designing my own gas system when I stumbled across the inline strafer. Doing some research led me here and I picked up a few more ideas. Everything below was done in about 3 hours or so on a lathe and cnc. This is basically the finished thing I just need to get co2 to test it. Once this works I will get back to my design.

Everything except small misc. parts


Uploaded with ImageShack.us
Vortex block


Uploaded with ImageShack.us
End cap, spring, plunger, and cylinder


Uploaded with ImageShack.us
End cap assembled


Uploaded with ImageShack.us
My mini valve/trigger


Uploaded with ImageShack.us
Standard aeg bucking/barrel


Uploaded with ImageShack.us
Assembled


Uploaded with ImageShack.us
In my m4 upper


Uploaded with ImageShack.us
This is what it should look like


Uploaded with ImageShack.us

[PVC Arsenal 17]

This is amazing work. Welcome to SpudFiles.

[jackssmirkingrevenge]

oooooh.... nice!

Are you planning to run it off unregged CO₂? (beware freezing problems from a high flow valve and no expansion chamber...)

Assuming the valve is a "push button" type, why didn't you orient it horizontally instead of vertically?

[Brian the brain]

Looks tight!

But I too wonder about the orientation of the valve...

[sagthegreat]

fap fap fap... lol

[Zeus]

Brian, how dare you question the orientation of the valve? It can't help how it was made.

Very nice work too, I love seeing machined stuff.

[Gun Freak]

Beautiful machining, nice implementation. Get some unregged CO2 up in there

[Karmatheninja]

Are you planning to run it off unregged CO₂? (beware freezing problems from a high flow valve and no expansion chamber...)

I already have a 2 stage regulated line on hand and I was considering using HPA because of that.

Assuming the valve is a "push button" type, why didn't you orient it horizontally instead of vertically?

It's a pull instead of a push. I was planning on having the trigger pivot on the small body pin over to the valve. A pull of the trigger would pull down on the bottom of the valve. If it was horizontal the trigger would be more complicated.

[jackssmirkingrevenge]

It's a pull instead of a push. I was planning on having the trigger pivot on the small body pin over to the valve. A pull of the trigger would pull down on the bottom of the valve. If it was horizontal the trigger would be more complicated.

OK, makes sense