How to loosen a pvc ball valve lever?

[Beastmode1607]

I'm making a homemade pneumatic air rifle and this will be my trigger to release the compressed air, i bought a pvc ball valve 1" and it's hard to turn, how can it make it easier? Thanks! Btw wd-40 will ruin it so that's out of the question lol

[jackssmirkingrevenge]

Silicone oil is a good idea, but it will always be a bit tight. You should extend the handle if you want to make it easier to turn.

[Beastmode1607]

Silicone oil is a good idea, but it will always be a bit tight. You should extend the handle if you want to make it easier to turn.

Will pneumatic tool oil work?

[jackssmirkingrevenge]

Assuming it's formulated not to attack seals, yes. Do not use anything which is not friendly to o-rings and the like.

[POLAND_SPUD]

Gently apply lubrication, then gradually loosen it up till it's perfect. Note that some lubricants can damage rubber/latex products

Funny how some things apply both to valves and wimin

[jackssmirkingrevenge]

Funny how some things apply both to valves and wimin

You say funny, I say convenient