pint sized LRPL-01

[spudshot]

this is a mini version of plasticex009's LRPL-01, the chamber is 2" and the barrel is 1", the piston is a 1.5" coupling with some slivers of 1.5" inside, the metal pieces are some brass parts from a lamp i believe, and the sealing material is sheet rubber. i lubricate the piston with Prestone Silicone Lubricant to make it actuate faster, i'm not sure if it works any better, but it seems too. it's a bit messy because i didnt find any clear primer until i was almost done with the project. the solenoid and fill system are the same from my copper piston cannon, i cant afford to buy a new valve now, i'm saving for 6" fittings for a combustion. there are two bumpers pictured, one is 19/32 rubber hose cut in half, the other is 1/4" air hose. i use both to make sure the piston is stopped well. just a few leaks to work out, but other than that this thing was louder and more powerful than i had expected. no damage pics, i cant get outside to shoot, too cold, and too much snow.

http://img157.exs.cx/img157/8050/mvc147f8qi.jpg
http://img157.exs.cx/img157/1134/mvc148f0bs.jpg
http://img157.exs.cx/img157/9127/mvc149f8tn.jpg
http://img157.exs.cx/img157/245/mvc150f9zu.jpg
http://img157.exs.cx/img157/2940/mvc151f7ol.jpg
http://img157.exs.cx/img157/3691/mvc152f2ta.jpg
http://img157.exs.cx/img157/15/mvc146f2hb.jpg