Mounting barrel support question

[Flying_Salt]

For my marble sniper I'm making a single barrel support much like the ones on the fish killer but because of the way my fitting (seen below) is shaped I won't be able to dremel out the inside so the pipe can slide through. I was thinking of cutting off a section of the bottom so there would be a rectagle-shaped hole. Then the pipe might fit? I wanted to ask here before I tried anything.

EDIT: You can see what I'm talking about on the tee's on the first picture of the fish killer.



Thanks,

Salty

[jrrdw]

You need a different tee. If you cut off the support tube, how you going to attach it to the down pipe?

[singularity]

if you cut away enough it would.... but it would always be wobbly. your probably better off just getting the right type of tee

[Flying_Salt]

Well I wnet ahead and did it all with a non-motorized saw (I ended up cutting across the length of that tee 4 times) and I cut off a little less than half of it. I had to resort to brute force to get it on, but I have just enough left on it so it has a nice n' tight grip. Picture coming soon.

EDIT: Here it is. I'm planning to sand off all the junk and make it neat and smooth.



Other progress can be found here http://s117.photobucket.com/albums/o60/ ... C00899.jpg
(Url tags didn't want to work)

[jrrdw]

That worked out for the best, cool. Are you going to glue/epoxy/solvent weld the barrel to the support? Or clamp it?

[Flying_Salt]

I might in the future, but as of now it fits tightly and I can pick up and move it around without the tee moving around.