attaching barrels to chambers.
Hey
I attached 8mmID copper barrel into my 20mm pvc barrel. I made a pvc sheet to fit into the 20mm barrel, then drilled a hole for the copper pipe. I then added about 2cm of epoxy glue to secure it in. I then did the same thing near the end of the barrel. It works fine, wouldn't trust it for high pressure for a long period of time, but it works fine for my 100psi rifle.
I attached 8mmID copper barrel into my 20mm pvc barrel. I made a pvc sheet to fit into the 20mm barrel, then drilled a hole for the copper pipe. I then added about 2cm of epoxy glue to secure it in. I then did the same thing near the end of the barrel. It works fine, wouldn't trust it for high pressure for a long period of time, but it works fine for my 100psi rifle.
Failure to plan is planning to fail.
The 7 P's - Proper Prior Preparation Prevents Piss Poor Performance
The 7 P's - Proper Prior Preparation Prevents Piss Poor Performance
What type of estimate? I'm in Australia. Mine was a 3/8" OD barrel from Auto One, it cost me about $20 for 3 feet.f.c wrote:i kind of get you're idea. epoxy was my original idea but i didn't know how reliable it would be. does anyone know and estimate on 8mm pipe in australia ?
Failure to plan is planning to fail.
The 7 P's - Proper Prior Preparation Prevents Piss Poor Performance
The 7 P's - Proper Prior Preparation Prevents Piss Poor Performance
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 2182 Views
-
Last post by jimmy101
-
- 9 Replies
- 2749 Views
-
Last post by daxspudder
-
- 2 Replies
- 3068 Views
-
Last post by jrrdw
-
- 10 Replies
- 2188 Views
-
Last post by JDP12
-
- 3 Replies
- 1392 Views
-
Last post by littlebro05
