1.Okay my thoughts are first a 158.276ci, 1.5in porting pvc triggered burst disk pnuematic. The problem with that is that it would be really annoying to pump up with such high volume estamated cost for that is $30.
2.Next turning my spray and pray into an advanced combustion but the problem is the chamber isnt pressure rated and i know people think non pressure rated pipe is fine for combustions but i am a cautious person.
101.75ci 2in porting exchangeable barrels, duel ignition, propane metered, chamber fan. Estimated cost $45. More money for something that would be less powerful than the first choice.
3.Make a mini adavanced combustion. 32.974ci 1in porting exchangeable barrels, duel ignition, propane metering, and a chamber fan. Estimated cost $40. the plus side of this over choice number two is that the chamber will be pressure rated.
4.start a metal high pressure triggered burst disk pneumatic similar to choice number 1 just out of metal. Estamated cost $120(I said start it I would finish it in a couple weeks if I do this).
5.Make a copper piston valved cannon. 30.171ci 1/2in porting QEV piloted.
estamated cost $50(there goes all my money)
6.make the excact same thing as in choice 5 just out of pvc. Estimated cost $10
7.Save it up for a compressor.
8.Save it up for a regulated scuba tank setup.
9.Get a shock pump.
10. Make the high pressure pump in gippedo's tutorial.
If you have any other ideas of what I should do please suggest them.
