I'm looking to make a nice new marble plinker that I can take to my spare block at Macleay Island for a bit of fun. I've gotta make the gun unscrewable so I can fit in in a bag so I can take it over on the ferry.
As far as sprinkler valves go, are there any that are better then others? E.g better made, or have higher flow?
...or is a sprinkler valve, a sprinkler valve?
Cheers in advance,
Mitch.
Aussie sprinkler valves - Best to get.
- koolaidman
- Specialist
- Posts: 156
- Joined: Sun Jun 24, 2007 7:46 pm
I believe what youre referring to is a sprinkler valve.Mitchza89 wrote:...or is a sprinker valve, a sprinker valve?
- elitesniper
- Sergeant
- Posts: 1090
- Joined: Sat Oct 13, 2007 8:40 pm
haha, mitch a nice new plinker? I reckon you got to many plinkers, ;D , but on topic most sprinklers are pretty much the same just keep the piloting volume to the lowest and your good to go, but why not a piston valve? You've made pretty darn good ones
Haha thanks alot for that Elite . Ehhh as much as I come up with new designs, I make probably a gun every 3 months, or mod an old one to make it better. If not, I just sit back and procrastinate... .
I might get an el' cheapo sprinker valve and make a custom phram' like what Noname did for his. Might be the best way to go.
Because I'm used to working with small bore pain in the arse pistons, a sprinker valve might be a nice alternative for a change .
I might get an el' cheapo sprinker valve and make a custom phram' like what Noname did for his. Might be the best way to go.
Because I'm used to working with small bore pain in the arse pistons, a sprinker valve might be a nice alternative for a change .
- elitesniper
- Sergeant
- Posts: 1090
- Joined: Sat Oct 13, 2007 8:40 pm
Yeah, if you do noname's mod to the sprinkler you will get very good performance and flow, probably similar to a Q.E.V., good luck!
- Pyro Ninja
- Specialist 3
- Posts: 351
- Joined: Mon Oct 09, 2006 7:11 am
- Location: Australia
Just use the sprinkler valves you buy from bunnings, good flow perfect seal etc etc....