filling multiple chambers at the same time

[trollhameran]

Im looking for ideas of a way to fill multiple chambers at the same time using a single compressor, the chambers will be 2 liter bottles and they cant be filled through the cap. Does anyone have an idea how to do this?

[MrCrowley]

[SpudFarm]

or you can use multiple TEE hose barbs to make many hoses of one.

[trollhameran]

Crowley what is that adapter called? so i can search it on google.

I had thought about using tees but i wanted to see if there was an easier way before i decided on using them or not.

[SpudFarm]

ok what about a 1/4" NPT cross that you put one male adapter in and three female quick connects?
should be cheaper

(a huge amount of hard spelled words in that post)

[trollhameran]

hmm thats a good idea spudfarm, would definately be cheaper than tees and would take up less place

[SpudFarm]

yepp

[trollhameran]

now just need to find somewhere to buy them in the UK.

While were on the subject, will epoxy glue 15mm pipe either copper or pcv in through the side or the bottom of a pet bottle and be able to hold pressure?

[SpudFarm]

i would not bet on that if i could not get it on the inside

[trollhameran]

If I could get the epoxy on the inside of the bottle could it work then?

[bigbob12345]

Well the epoxy will stick fine to the copper or pvc but it wont stick very well to the bottle and will eighther leak or just blow off.

[trollhameran]

Hmm thats kinda buggered me up then, know of anything that will stick to both and will hold pressure?

[SpudFarm]

if you get a nice layer on the inside of the bottle around the pipe. it sticks to the pipe making it to big to go through the hole

[trollhameran]

so if i did that and then stuck an o ring to the pipe on the outside of the bottle so it was tight against the bottle then it should hopefully work then

[psycix]

Why use a bottle if you can also use PVC?
Its worth those few bucks.