building some kind of motor vehicle
-
shadowmaster123
- Private
- Posts: 6
- Joined: Wed May 24, 2006 8:27 am
i have a 2 horse power lawnmower engine and i want to build something that i can drive. i am open to any suggestions. i was hoping a bike with a lawn mower engine or some kind of little pocket bike.
-
shadowmaster123
- Private
- Posts: 6
- Joined: Wed May 24, 2006 8:27 am
i have no experience in building this any ideas
-
sergeantspud2
- Specialist 3
- Posts: 315
- Joined: Tue Jun 07, 2005 5:43 pm
- Location: So Cal
If its a vertical shaft there isnt much you can do with it. Im trying to think of something to do with my vertical shaft engine and the only thing I can find is to make a generator like this http://theepicenter.com/tow082099.html
Always rely on Murphy's Laws 4.If you have enough grease & a big enough hammer, you can put anything... anywhere
3.If all else fails, hit it with a big hammer
2.Matter will be damaged in direct proportion to its value
1.If anything simply cannot go wrong, it will anyway
-
jrrdw
- Moderator
- Posts: 6572
- Joined: Wed Nov 16, 2005 5:11 pm
- Location: Maryland
- Has thanked: 39 times
- Been thanked: 22 times
- Contact:
Find any old rideing mower with a seprate transmission, they most allways have a vertical input and horizontal output + you get 3 forward speeds and reverse. Just put a slightly bigger pulley on the engine to get more sp8eed, the transmission can handle it. I once had a old Montgumary Wards rideing mower and used a bigger drive belt on the deck drive pulley to run the transmission, i bet it ran at least 20mph in third, had to leave the clutch out, (was not in line with the new set up), and just banged the gears. It was rough takeing off and hard to get into 2nd without going into reverse but i got the hang of it.