How did you go about cutting your breech hole?

[jmeyer1022]

I'm breech loading golf balls and I was wondering how you guys cut your holes. I'm sure most people will say they used a core bit drill or along those lines, I was wondering if anyone used something different.

[frankrede]

Dremel, Hacksaw?

[roboman]

Dremels work great.

[inonickname]

Dremel, mitre saw, jigsaw, hacksaw, router, holesaws. Whatever you want.

[FishBoy]

coping saw has not been mentioned

[Brian the brain]

Your other GB cannon?

A bbmg??


You can use whatever you got.

Just make sure the hole has no square angles, this may weaken the pipe.
Keep the hole as round as possible.No point for a tear to start from...

[trae08]

bandsaw jigsaw sawzall rotozip

whatever you can do it with dosnt have to be anything certain. just cut the hole and clean it up with some sand paper.

[maggotman]

on my copper cannon i made the breech buy holding it up to a bench grinder

[Sticky_Tape]

Dremel with (I think carbon) cut off disk(s). Win.

[psycix]

CNC milling machine, laser cutting, plasma gun vaporising, antimatter annihilating, just anything that is in your reach and can cut the material can be used!

[dudeman508]

Since i dont have any electric cutting tools i used a hack saw to cut two holes and then went over the other cut sites with a nife a bunch of time then bent it of with plyers.