Paintball Sniper, Sleek and Powerful

[K-Dawg-]

Today i went down ace and scouted out potential barrels. I found an almost perfect match, 1/2" SDR 13.5 PVC. It is thin walled but it is NSF-PW and rated at 315 psi. Although schedule 80 3/4" would have been better I believe it will still be safe. I made a true bolt system using the 1/2" pvc and 1/2" CPVC. At 60 psi GGDT predicts a paintball going 500 fps, which is fast enough for me, and a safe operating pressure IMO. However, I may wrap the barrel in duct tape or electrical tape to prevent any nicks that could weaken the PVC.

[kjjohn]

nice, sleek design. your breech loader is neat. What do you pressurize it to?

[K-Dawg-]

Thanks! Anywhere between 45 to 80 psi is the norm.

[urgle the danish cow]

nice job mate. clean, well built and pretty BA

[sssssbooom]

This reminds me of my old "sniper like" cannon before it fell off of a 8' tall shelf into concrete and smashed into pieces every where thanks for making me want to cry lol
anyways nice cannon

[AxelTheWicked]

what did you do to modify the sprinkler valve?

[spudtyrrant]

what did you do to modify the sprinkler valve?

look it up on youtube, not trying to be rude but spoonfeeding is looked down upon here.

[jmadden91]

what did you do to modify the sprinkler valve?

Search Next Time...

[AxelTheWicked]

ok, thanks. i got it. and i'm almost finished with my rifle. i actually built a similar version of the rifle that KDawg posted. the only difference is that i added a handle for the blowgun valve. it was a b!+€# to put together. lol!