
I fuel it with a syringe. Uses 1,8 ML of butane per mix number.





[youtube][/youtube]
[youtube][/youtube]
...down to the plastic electrical connector as a burst disk holderLabtecpower wrote:Inspired by JSR's hybrids of course
hectmarr wrote:You have to make many weapons, because this field is long and short life
hectmarr wrote:You have to make many weapons, because this field is long and short life
Labtecpower wrote:Sadly my hybrid blew up at the first shot
hectmarr wrote:You have to make many weapons, because this field is long and short life
jackssmirkingrevenge wrote:The fact that you used "blew up" and ":D" in the same sentence means that you are now a true builder of epoxy based hybrids, congratulations!
Thanks for both complimentsjackssmirkingrevenge wrote:Very well drawn I have to say
Might as well add some screws while you're at it, learn from others' mistakesLabtecpower wrote:Now the front is the weakest part....
hectmarr wrote:You have to make many weapons, because this field is long and short life
That's what.... he said? Hmmm...Labtecpower wrote:I forgot the epoxy while I inserted it
1 hour epoxy needs at least 3 hours to be fully curedI use 1-hour epoxy, so i'm ready for some testing. I don't think sad troll and Y U No guy will survive.![]()
hectmarr wrote:You have to make many weapons, because this field is long and short life
I was wondering why it was leaking so badly. I closed all the leaks with epoxy, and it held pressure just fine. Now I don't have a single leak at the first try, so it should be better.jackssmirkingrevenge wrote:How did it hold pressure then? or is there an o-ring somewhere?
Feel free to publish them for scrutinyI did some extra calculations, and I discovered I used twice as much fuel as I should have. I think this is why I found the power a bit sloppy.
hectmarr wrote:You have to make many weapons, because this field is long and short life