Mini Hybrid

[SpudStuff]

You need to have a piece of acrual pipe threaded for this. thoes Molded Sprinkler risers just win't cut it. They are thick but often have defects.

[Benny]

noname are you australian?

[SpudStuff]

no he lives in california ~35 miles from me.

[Benny]

Ahh, ok.

[noname]

Spudstuff, by sprinkler risers do you mean the different lengths of SCH 80 3/4" and 1/2"? Most of them around here actually say "3/4" SCH 80 940 PSI @ 73 DEGREES" and then all the ASTM ratings and stuff like that. At Ace Hardware, in the back they have pipe cutters and dies going from 1/8" to 2", so I'll just get a piece that has the pressure rating on it, cut it to size, then use a 3/4" or 1/2" die to thread both ends.

[SpudStuff]

Oh okay then. The Home Despots (had to do that) only have molded ones.

[Jolly Roger]

Hey dude, I'm just not sure bout your BBQ lighter thats all. Your gaps are going to have to be really small being such as dense mix. You could incorporate a capacitator into the design. And did your little sister draw that design for you? (Sorry man had to say it)

[spanerman]

you are goin to need a realy smal gap with tht mix id say use a disposable camera curcuit and double up on capasitors and use the bolt through and jb weld

peace,sam.

[noname]

I'll just make a really small gap.
Jolly Roger, I don't even have a little sister. It was just a rush job using only the pencil in Paint.

[Jolly Roger]

Yeah jokes man...