stopping balls rolling out of barrel

[RAYZOR51]

I have read a post from 2007 regarding putting a dent in the barrel to stop this problem. The balls that were discussed were 6mm plastic in a brass barrel, I have 7.5mm and 9.5mm steel balls (two different barrels of course) in aluminium barrels.

My question is will this solution work with my setup, or is a different solution required.

[jrrdw]

Yes, it will work for all sizes.

[jackssmirkingrevenge]

It will work, but since steel is harder than aluminum, the dent will wear smooth over time. An o-ring in a fitting or a spring loaded ball detent is a better idea.

[matti]

Spring loaded set screws, you can find them in sizes starting from M3 thread.

http://www.dmeeu.com/en/catalogue/d/ind ... set-screws

[jackssmirkingrevenge]

Spring loaded set screws

I had no idea these existed, fantastic find!

Ball detents for the people!

Not too expensive either: http://www.ebay.com/itm/Vlier-Metric-St ... 20d43673fb

[RAYZOR51]

Thank you very much for your help, I am sure I will be in need of further assistance and it is good to have a reliable source of knowledge available.

Thanks