Golf ball barrell

[haulinick]

I heard that sleeving 2" sch 40 pvc with another piece of 2" sch40 will make a barrell perfect for golf balls. But I have also heard of sleeving sdr21 in 2" sch80. Which will work better? And what is the best way to aquire a piece of sdr21?

[squeaks]

I'd just go with sleeving it, it would be much easier, probably cheaper too.

[CS]

If you have very low standards of 'perfect', then yes.

All the sleeving attempts ive seen have never came close to the fit in that of SDR-21. There is something like a 3/8" or so gap left from the sleeving. Also typically two walls 'grab' the GB and there is a 1/32" or so gap left on the other two sides perpidicular to the 'grabbing'.

"The Gap"
<img src="http://loose-cannon.home.mindspring.com ... 002513.jpg">
"The Fit"
<img src="http://loose-cannon.home.mindspring.com ... 002525.jpg">

Sleeved and Un-Sleeved GB Barrels can be bought from me. To get a quote shoot me a email at sales.vivi@gmail.com and provide me with your ZIP code, desired length(s), and if youd like the length(s) to be sleeved or not.

[experament_u2]

can any one tell me wat size pipe takes golf balls other than SDR-21 because iv tryed 400mm and it was to small so wat can i sleve (in mm if its not to much troble)

[-T0OL-]

well, from what i read a golf ball is 1.680" so 1.680x2.5x10 = 420mm

(there are 2.5 cm in an inch and 10mm in a cm)

[boilingleadbath]

Mind your zeros; 400 mm is bigger than your head!