My QEV copper cannon

[spanerman]

made some impovements today...

[Kenny_McCormic]

thats a nice gun but id take it to 200 psi

[spanerman]

id take it to 23kpa if i had a pump that would do it

[joannaardway]

I think you mean 2300kPa.

23kPa is almost nothing.

[spanerman]

yes i do, or 0.23MPa, my bad

[MrCrowley]

100kpa = 1BAR
1MPa = 10BAR
700Kpa = 100PSI(Roughly)
7BAR = 100PSI(Roughly)
10BAR/1MPa = 145PSI
23Kpa = Jack sh*t

[spanerman]

yeah, my statement was correct id feel happy taking it to 250psi

[joannaardway]

That would be 2.3 mPa.

Again, .23 mPa isn't a lot (about 30 psi.)

[spanerman]

damn, got it wrong again. runs off to physics folder.

[chaos]

man whats the c:b ratio on this thing?

have you considered using a blowgun for the trigger?

[spanerman]

i have considerd a blowgun, i have used one, the perfomance suffers as the flow rate is so small, there is about a 1:1 ratio

[jackssmirkingrevenge]

id take it to 23kpa (edit: for which read 250 psi ) if i had a pump that would do it

If you don't mind the effort, you can get yourself a mountain bike shock pump relatively cheaply, it'll be low volume so pumping up might take a while (I suggest you use your compressor first then top up with the shock pump) but the performance increase for specific targets is more than worth the effort

[MrCrowley]

Pretty sure it wouldn't take long to get to 23kPa

[joannaardway]

Hmm, you could probably get 23 kPa from a balloon pump.

[spanerman]

28mm!!!!




should be solderd today