Some specs:
Chamber volume: 40 cc/cm3
Chamber length: 1,5"
Chamber dia.:1,4"
Barrel volume: 3cc/cm3
Barrel length: 9"
Caliber: 0.08"
Ch/Brr ratio : 13
As you see there are 2 s.s tubes going in the chamber. The first is the hydrogen/oxygen mix inlet and is flattened on the inside so it only allows very little gas flow.That way the chamber is filled slowly and when combustion happens very little gas is returned back.The second tube is where the sparker goes in(sorry not in the pics). The fuel is pure oxygen/hydrogen from an electrolyser(can take a pic of it if onyone's interested). I haven't yet had time to test the gun thoroughly, but it's quite powerful.As you see in the pics the barrel is removable. I have a longer one which is 15", but it only seems to enchance the performance by little. After a week or so I'll be able to take damage pics and maybe shoot a vid if anyone's interested.
Safe and happy spudding everyone!
EDIT:
Oook , so here's the electrolyser:
Electrolyser Diagram
Electrolyser1
Electrolyser2
Electrolyser3
The whole thing is less than a foot high.For electrolyte i use baking soda. When i run it at 12v it puts out about 100cc/minute(haven't measured it though, just think so). There are a couple ways i connect it to the gun. The first is directly, which sometimes makes the rubber cork pop out(should fix that).The second is feeding the h2/o2 mix into a syringe and then injecting the syringe into the gun.
